Canon P-150 Bedienungsanleitung

• Please read this manual before operating this scanner.• After you finish reading this manual, store it in a safe place for future reference.Referenc

10Using the ScannerSetting the Auto Start switch on the rear of the scanner allows you to use the scanner in the following two ways.When Using the Sca

11Scanning with CaptureOnTouch LiteA Turn ON the computer.B Set the Auto Start switch on the scanner to ON.C Connect the scanner to the computer using

12When the scanner turns ON, the computer recognizes the scanner as a storage device, and the auto play screen appears.When you click [CaptureOnTouch

13Click [Scanner setting] to display the [Scanner setting] dialog box, and to configure the basic scan settings.A Specify the scanning mode (color, gr

14A Click [Start] or press the start button on the scanner.• The documents are scanned and ejected when scanning is finished.• The scanned document is

15A Click [X] to close CaptureOnTouch Lite.B Close the feed tray.C Disconnect the USB cable.Using Windows 2000Before closing the feed tray, double-cli

16Scanning with CaptureOnTouchDo not connect the scanner to the computer before Installing CaptureOnTouch.Insert the Setup disc into the computer’s DV

17A Place the scanning side of the documents face down into the scanner, and press the start button on the scanner.CaptureOnTouch starts automatically

18A Click on the taskbar, and click [Launch CaptureOnTouch].B Select whether to scan using [Scan First] or [Select Scan Job] by clicking the respect

19Common Problems and SolutionsThis section provides recommended solutions to common problems.If you have a problem that is not solved by the followin

2READ CAREFULLY BEFORE OPENING THE SEALED DISK PACKAGECANON SOFTWARE LICENSE AGREEMENTIMPORTANT-READ THIS AGREEMENT BEFORE OPENING THE SEALED DISK PAC

20Problem 5 Documents fed askew are causing scanned images to be slanted.Solutions (1) Align the document guides to fit the documents as closely as po

21Replacing PartsThe feed roller and separation pad inside the scanner wear with scanning. If the feed roller and separation pad are worn, documents m

22C Open the roller cover.D Lift up the roller lock lever, and slide it to the left.E Remove the feed roller.F Attach the feed roller. Align the notch

23I Close the feeder cover.Use the following procedure to replace the separation pad.A Open the feed tray.B Open the feeder cover.C Remove the separat

24E Close the feeder cover.Make sure to reset the scanner’s internal counters using the following procedure whenever you replace the feed roller and s

25G Click the [Maintenance] tab.H Click [Reset] for both [Current Rollers] and [Current Pad].The counter for [Current Rollers] and [Current Pad] reset

CANON ELECTRONICS INC.1248, SHIMOKAGEMORI, CHICHIBU-SHI, SAITAMA 369-1892, JAPANCANON U.S.A. INC.ONE CANON PLAZA, LAKE SUCCESS, N.Y. 11042, U.S.A.CANO

3Table of ContentsImportant Safety Instructions ... 4Installation Location ...

4Important Safety InstructionsTo ensure the safe operation of this scanner, make sure to read the safety warnings and precautions described below.Inst

5AC Adapter (Not Supplied)● When using an AC adapter (not supplied) to power the unit, make sure to read the operating manual for the AC adapter.● Use

6 When disconnecting the USB cable, grasp it firmly by its connector. Do not pull directly on the USB cable, as this may damage or expose the cable’s

7Checking the AccessoriesSupplied Accessories•USB Cable• Power Supply USB Cable• Separation Pad• Warranty Card• Reference Guide (This Document)• Softw

8Attaching the Separation PadUse the following procedure to attach the supplied separation pad before using the scanner.A Open the feed tray.B Open th

9D Close the feeder cover.Power SupplyThis scanner is powered via the supplied USB cables.(The USB connector to which the scanner is connected on your