Canon EOS EOS-1D Anleitung zur Fehlerbehebung Seite 162

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 176
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 161
162
The battery has almost exhausted.
s
Recharge the battery. (p.22)
Only the < >
icon is displayed on
the top LCD panel.
The battery
cannot be
recharged.
You are using the wrong battery.
s
Use the dedicated Ni-MH Pack. (p.22)
The battery is not properly attached to the charger.
s
Attach the battery properly to the charger. (p.22)
The camera does
not operate even
when the <
>
switch is set to
<
>.
The battery is exhausted.
s
Recharge the battery. (p.22)
The battery is not installed properly.
s
Install the battery properly. (p.23)
The CF card slot cover is open.
s
Push in the CF card until the CF card release button pops up. Then
close the CF card slot cover. (p.27)
The access lamp
still blinks even
when the <
>
switch is set to
<
>.
If you set the <
> switch to < > right after taking a picture, the
access lamp will still blink for a few seconds while the image is recorded
onto the CF card.
s
When the camera finishes recording the image to the CF card, the
access lamp will stop blinking and the power will turn off.
The battery
becomes
exhausted
quickly.
The battery is not fully charged.
s
Recharge the battery fully. (p.22)
The battery’s service life has expired.
s
Replace the battery with a new one. (p.166)
The camera turns
off by itself.
Auto power off is in effect.
s
Set the < > switch to < > again or set auto power off to “Off.
(p.130)
Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide.
Power Source
Seitenansicht 161
1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 175 176

Kommentare zu diesen Handbüchern

Keine Kommentare