Canon iP6600D - PIXMA Color Inkjet Printer Wartungshandbuch

PIXMA iP6600DSERVICEMANUALCanonCopyright 2005, Canon U.S.A. This technical publication is the proprietary and confidential information of Canon U.S.A.

1-5. Serial Number Location On the carriage flexible cable holder (visible on the left of the carriage after the printer is turned on, and the panel

2. LIST OF ERROR DISPLAY / INDICATION Errors and warnings are displayed by the following ways: 1) Operator call errors are indicated by the Alarm LE

[1841]*2 inner cover and press [OK]. the Stop/Reset button.󲇗 Inner cover open during printing on paper. [1846]*2 Close the inner cover, and press the

*1: Only for models supporting CD / DVD printing *2: Only for models not supporting CD / DVD printing 2-2. Service Call Errors (by Cyclic Blink

- Logic board ass'y (QM2-2745)*1 - Paper feed motor (QK1-1502) 4 times Purge cam sensor error [5C00] An error occurred in the purge unit. - Purg

*1: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information print). If the waste in

2-4. Warnings Warning Message on the LCD SolutionLow ink The following ink is low. Continue? (Icon of each ink tank) Yes No - Select Yes, a

2-5. Troubleshooting by Symptom Symptom SolutionFaulty operation The power does not turn on.The power turns off immediately after power-on. - Con

*1: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information print). If the waste in

3. REPAIR 3-1. Notes on Service Part Replacement (and Disassembling / Reassembling) Service partNotes on replacement*1Adjustment / settings Operatio

product. When changes are made to the contents of the manual, Canon will release technical information when necessary. When substantial changes are ma

*1: General notes: - Make sure that the flexible cables and wires in the harness are in the proper position and connected correctly.[See 3-2. Special

3-2. Special Notes on Repair Servicing (1) External cover removal (I) Open the access cover, and release the hooks on the left and right side of th

(III) Release the hooks and remove the front left cover as shown below.

󲇗 󲇗 󲇗 (2) Flexible cable and harness wiring, connection Be careful of wiring of the flexible cables and harness. Improper wiring or connection m

1-19

(II) Paper feed motor side wiring 󲇗 To the table of contents To the top<Part 1: 3. REPAIR, 3-2>1-20

3-3. Adjustment / Settings (1) Paper feed motor adjustment Perform the following adjustments when the paper feed motor unit is replaced: 1) When at

2) CL input gear 󲇗 󲇗 1-22

3) PR shaft / LF roller bushing 󲇗 󲇗 󲇗 To the table of contents To the top<Part 1: 3. REPAIR, 3-3 (1) to (2)>1-23

(3) Waste ink counter setting When the logic board ass'y is replaced, reset the waste ink counter. In addition, according to the waste ink amoun

I. MANUAL OUTLINE This manual consists of the following three parts to provide information necessary to service the PIXMA iP6600D: Part 1: Maintenanc

(5) Service mode Note: At the end of the service mode, press the Power button. To protect the media sensor from being dislocated during transportati

Note: If the Stop/Reset button is pressed 15 or more times, the Alarm or Power LED lights steadily without any changes. <Destination settings proc

[See 3.4. Verification Items, (1) Service test print, or (2) EEPROM information print.] <Button and LCD test procedures> Purpose: To confirm t

3-4. Verification Items (1) Service test print <EEPROM information contents> On the service test print (sample below), confirm the EEPROM info

<Service test print sample> (2) EEPROM information print <How to read EEPROM information print> Print sample: 1-29

1:iP6600D JPN 2:V1.02 3:IF(USB2=1) 4:D=004.9 5:ST=2005/06/27-18:30 6:ER(ER0=1000 ER1=5100 ) 7:LPT=2005/07/04-09:09 8:PC(M=002 R=000 T=001 D=009

24. Auto duplex print pages (total, Photo Paper Plus Double Sided, postcard) 25. Camera Direct print pages (total) 26. Borderless print pages 27.

4. PRINTER TRANSPORTATION This section describes the procedures for transporting the printer for returning after repair, etc. 1) In the service mode

Part 2 TECHNICAL REFERENCE

1. NEW TECHNOLOGIES (1) New ink tank system (CLI-8) An LED is installed in each ink tank. By the LED indication, wrong installation of the ink tanks

II. TABLE OF CONTENTS Part 1: MAINTENANCE 1. MAINTENANCE 1-1. Adjustment, Periodic Maintenance, Periodic Replacement Parts, and Replacement Consuma

To the table of contents To the top<Part 2: 1. NEW TECHNOLOGIES>2-2

2. CLEANING MODE AND AMOUNT OF INK PURGED To prevent printing problems due to bubbles, dust, or ink clogging, print head cleaning is performed before

Deep cleaning - Via the operation panel - Via the printer driver 1.346 60 To the table of contents To the top<Part 2: 2. CLEANING MODE AND AMO

3. PRINT MODE 󲇗 󲇗 3-1. Resolution in Printing via Computer 󲇗 3-2. Resolution in Borderless Printing 2-5

󲇗 3-3. Resolution in Duplex Printing 󲇗 3-4. Resolution in Camera Direct Printing 󲇗 3-5. Resolution in Card Direct Printing 󲇗 To the table of co

4. FAQ (Problems Specific to the iP6600D and Corrective Actions) No. * Function Phenomenon Condition Cause Corrective actionPossible call or complain

4 APrint resultsas A4) is printed.- With Photo Paper Plus Double Sided or postcards, the phenomenon is likely to be noticeable and to be complained of

*1: Change the paper in each Bottom plate cleaning. The cleaning can end when paper does not get any soiling. *2: Locations to clean in servicing wh

󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗󲇗 *3: How to prepare and set the ASF sub-roller cleaning sheet: 1) Fold a sheet of plain paper lengthwise in half. 󲇗 󲇗 2) Fo

󲇗 3) Moisten the folded end portion (indicated by the blue circle in the figure below) using a wipe, and set the paper in the ASF so that the moiste

3-4. Resolution in Camera Direct Printing 3-5. Resolution in Card Direct Printing 4. FAQ (Problems Specific to the iP6600D and Corrective Actions

󲇗 To the table of contentsTo the top<Part 2: 4. FAQ>2-12

Part 3 APPENDIX

3. PIXMA iP6600D SPECIFICATIONS <Printer> Type Desktop serial color bubble jet printer Paper feeding method Auto sheet feed (ASF, cassette, aut

*1: Only for CD / DVD printing supported regions <Direct printing> Print head alignment Available (automatic or manual alignment via printer d

* Adapter required. Throughput- A photo from a 5 mega-pixel digital camera - 4 x 6 borderless - Exif print - Standard print quality - Process from

*1: Only for CD / DVD printing supported regions <Print head> 󲇗 <Supported ink tanks> O: Usable X: Not usable Note: The ink tanks f

4. PRINT MEDIA SPECIFICATIONS <Plain paper / specialty paper> The following types of paper are recommended: Type Name Size Paper feeding me

*1: ASF only for LGL *2: When A4 or LTR is selected for Paper Size, plain paper is selectable for Paper Type. With plain paper selected for Paper T

Part 1 MAINTENANCE

1. MAINTENANCE 1-1. Adjustment, Periodic Maintenance, Periodic Replacement Parts, and Replacement Consumables by Service Engineer (1) Adjustment No

There are no consumables that require replacement by a service engineer. 1-2. Customer Maintenance 1-3. Product Life (1) Printer Specified print vo

(2) Print head Print volume: 10,000 pages (3) Ink tank (target value) 󲇗 Black 1,500 character pattern 2,000 pages ColorA4, 7.5% duty per color patt