Canon LV-WX300 Bedienungsanleitung PDF herunterladen (Seite 33)

ENGLISH

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 quick-release adjuster foot and 1

rear adjuster foot. These adjusters change the image height and

projection angle. To adjust the projector:

1. Press the quick-release button and lift the front of the projector.

Once the image is positioned where you want it, release the

quick-release button to lock the foot in position.

2. Screw the rear adjuster foot to fine tune the horizontal angle.

To retract the foot, hold up the projector while pressing the quick-

release button, then slowly lower the projector. Screw the rear

adjuster foot in a reverse direction.

If the projector is not placed on a flat surface or the screen and the

projector are not perpendicular to each other, the projected image

becomes trapezoidal. To correct this situation, see "Correcting

keystone" on page 34 for details.

• Do not look into the lens while the lamp is on. The strong

light from the lamp may cause damage to your eyes.

• Be careful when you press the adjuster button as it is close

to the exhaust vent where hot air comes from.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do

this, press AUTO PC on the projector or remote control. Within 3

seconds, the built-in Intelligent Auto Adjustment function will re-

adjust the values of Frequency and Clock to provide the best picture

quality.

The current source information will be displayed in the upper left

corner of the screen for 3 seconds.

• The screen will be blank while AUTO PC is functioning.

• This function is only available when a PC signal (analog

RGB) is selected.

Fine-tuning the image size and clarity

For adjusting the size to your desired, you need to move the

product for appropriate projection distance because of small Zoom

ratio. Follow the procedure below for the installation and

adjustment.

The focus will be off after adjusting the zoom, so be sure to

readjust the focus. If the image is very blurry, adjusting the focus to

make the image sharp will change the size of the projected image.

Repeat the zoom and focus adjustments in alternation as necessary.

In the right figure, (A) Focus Ring, (B) Zoom Ring

1. Adjust Zoom. (using (B) Zoom Ring)

2. For the short distance/large screen, dial the ring fully to Wide

end. For the long distance/small screen, dial the ring fully to

Tele end.

3. Adjust Focus. (using (A) Focus Ring)

4. Move the product back and forth to adjust the screen size.

5. Adjust Focus again if necessary.

Tele

Wide

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 76 77

Kommentare zu diesen Handbüchern

Keine Kommentare

Canon LV-WX300 Bedienungsanleitung Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Datenprojektoren Canon LV-WX300