Canon BJ-200e Bedienungsanleitung PDF herunterladen (Seite 69)

Printing Problems

This section contains problems and solutions related to your printer or

the software you are using.

Printout is Wrong

If strange characters appear in your output, there may be a

communications problem between the printer and your computer.

If your printed output does not appear as you expect, follow these steps:

1. Make sure your cable connections are secure.

2. Check that the printer control mode (BJ-10 or Epson LQ)

matches the printer driver you selected. See Chapter 5, Using the

Printer With Your Software, for details on selecting a printer

driver and a printer control mode.

Characters on Screen Do Not Match Printed Characters

Many graphics characters and special symbols are produced by different

ASCII codes on each make of computer and printer. Set the correct

character table and printer control mode with the DIP switches.

If you would like to receive a printout for the character sets available in

BJ-10 mode and Epson LQ mode, you can use Canon's toll-free fax

retrieval system. Call the Canon help desk at 1-800-423-2366 and ask

for the fax retrieval system. Then request the BJ-200e Printer Command

Summary. This document includes samples of each available character

set.

Printing Beyond Edge of Page

If the printer is printing only part of each line, follow these steps:

1. Make sure the paper is aligned correctly in the sheet feeder.

2. Check the software setting for the correct margins.

3. Check the setting of DIP switch 1. This DIP switch controls the

horizontal print position:

For letter-size paper, set it to OFF.

NOTE: Make sure your interface cable is no longer that 6.6 feet. Avoid

using A/B switch boxes or switch boxes that have a total cable length of

more than 6.6 feet.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 85 86

Keine Kommentare

Canon BJ-200e Bedienungsanleitung Seite 69