Canon IMAGEFORMULA CR-190I Bedienungsanleitung

Please read this manual before operating this scanner.Instructions

10 Keep the area around the power outlet clear of all obstacles so you can disconnect the power cord easily at all times. Never spill water or volat

11• Places subject to rapid changes in temperature or humidityCondensation occurring inside the scanner may impair image quality. Place the scanner in

12Introduction to the CR-190iThis chapter describes the features of the CR-190i scanner, what comes packaged in the box, and the names and functions o

13Ultrasonic Double Feed Detection and Double Feed Detect OFF Button (Scanning Utility for CR-190i)The scanner detects double-fed documents using ultr

14This section describes the names and functions of each part. Before you connect the CR-190i, familiarize yourself with its parts and their functions

15Back Maintenance CoverOpen this cover to clear paper jams or to clean the scanner.Separation OFF Mode ButtonUse this button when you want to scan th

16Rear ViewCAUTIONTo avoid overheating and causing a fire, never block the air vents on the back of the scanner.ConnectorUnits: inches (units in paren

17Preparation Before UseThis chapter describes how to prepare the scanner to scan documents.Perform the following steps to set up the CR-190i. Refer t

18The following computer system requirements are recommended for using the CR-190i.Operating Systems:• Microsoft Windows XP (32bit) SP3 or later• Micr

19The following software applications are provided on the setup disc that is packaged with the scanner. Make sure to open and read the Readme.txt file

2Connecting the Scanner to a ComputerConnect the CR-190i to a computer as follows. Make sure to install the software before connecting the scanner to

20D Click [Accessories], and then click [Run].E Enter “D:\SU190i\setup.exe” in the [Open] fields, and then click [OK].Installation starts.F Follow the

21Connecting the Power CordConnect the power cord.Make sure to use only the power cord provided with the scanner.WARNINGWhen connecting the power cord

22B Turn ON your computer.C Windows recognizes the CR-190i as new hardware, and installation starts automatically.NOTEThe CR-190i will be registered a

23This section describes how to prepare the ink cartridge so that you can use the imprinter to print text or a bitmap on scanned documents.About the I

24C Place the ink cartridge shown in the diagram below.CAUTIONDo not touch the electrical contact on the carriage. Doing so may cause a malfunction.NO

25SoftwareThis chapter describes how to use the Scanning Utility and the Ranger.This section describes how to start up the Scanning Utility so that yo

26NOTEThe basic operation of the Scanning Utility is noted in the Scanning Utility help file. On the [Help] menu, click [Help] to view the explanation

27F Select the scanning method from the [File] menu and start scanning.G When scanning is finished, click [Exit] on the [File] menu to quit the Scanni

28C Click [Start], and then click [All Programs].The procedure in Windows XP/7 is different from the ones described in this manual. Refer to the Windo

29This section describes how to uninstall the Scanning Utility and the Ranger.IMPORTANT• Be sure to log on as the Administrator.• The procedure in Win

3READ CAREFULLY BEFORE OPENING THE SEALED DISK PACKAGECANON SOFTWARE LICENSE AGREEMENTIMPORTANT-READ THIS AGREEMENT BEFORE OPENING THE SEALED DISK PAC

30IMPORTANT• If you uninstall the “Scanning Utility for CR-190i” you also need to uninstall the “Canon Driver for CR-190i.”• If you uninstall the Rang

31Document Feeding and ScanningThis chapter describes precautions regarding documents that can be handled on this scanner and scanning operations.This

32NOTE• Note that mixing documents of different thickness may cause a malfunction during feeding.• Curled, wrinkled, or folded documents may cause an

33Using Ultrasonic Double Feed DetectionThe double feed detection function that the scanner is equipped with uses the penetration of ultrasonic waves

34Placing DocumentsNote the following points when placing documents on the scanner.• Place the front of the document toward you.• Do not exceed the Lo

35This section describes how to load and scan documents.CAUTION• Avoid wearing loose fitting clothing, dangling jewelry, long ties, or long hair that

36IMPORTANT• If you press the JOG Button when a batch of documents of various sizes are loaded, the alignment will be incomplete, and the documents wi

37• When Using the Accompanying Scanning Utility for CR-190i:Scanning is suspended and a message is displayed when the Eject Pocket becomes full of do

38TroubleshootingThis chapter describes the problems that might occur in the CR-190i, and how to remedy them.The following causes and remedies describ

39B Press and hold the START Button.The jammed document is ejected into the Eject Pocket.If the above procedure does not clear the paper jam, perform

4FCC REGULATIONS (For 120V model)Check Reader, Model M111021This device complies with Part 15 of the FCC Rules. Operation is subject to the following

40G Close the Front Maintenance Cover in the order shown in the diagram below.

41If the document is not fed properly or the detection functions do not work properly, remedy the problem by checking the following conditions.Feeding

42If there is a problem with the scanned image (the image is not sharp or stripes appear), one of the following conditions may be a probable cause. Ch

43MaintenanceThis chapter describes how to clean and maintain the scanner.To ensure high-quality image scanning, regularly clean your CR-190i as descr

44B Press the Open Button, and push the Back Maintenance Cover open to the back.C Wipe the feed path with a firmly wrung cloth, moistened slightly wit

45Cleaning the Scanning Glass and RollersIf stripes appear on scanned images or if dirt appears on scanned documents, clean the scanning glass and rol

46E Spin the rollers while wiping them clean with a firmly wrung cloth dampened with water or a mild detergent.There are 26 roller positions, as shown

47H Close the Front Maintenance Cover in the order shown in the diagram below.I Replace the Roller Cover.J Carefully replace the Top Cover.IMPORTANTIf

48Cleaning the Magnetic HeadsIf the magnetic heads are dirty, then MICR characters cannot be scanned correctly. Periodically, clean the magnetic heads

49Cleaning the Ink Jet NozzlesInk that collects around the ink jet nozzles may stain your documents or cause the text or bitmap to appears as scratche

5Trademarks• Canon and the Canon logo are registered trademarks, of Canon Inc. in the United States and may also be trademarks or registered trademark

50Cleaning with the Cleaning Cards (U.S.A. Only)If a black stripe appears on the back-side of scanned images or if dirt appears on the paper documents

51Make the following adjustments to maintain scanning quality.Replacing the Ink CartridgeThe ink cartridge needs to be replaced if the printed text be

52E Carefully replace the Top Cover.Replacing the Ink Disposal TankWhen the following conditions appear, you have to replace the ink disposal tank acc

53NOTE• Be careful not to get dirty with ink.• When you discard the ink disposal tank, put it in the plastic bag in the box of the ink disposal tank.C

54C Open the Feed Supporter to the left.D Pinch the Separation Roller at the rim and the fixing lever, and then remove it with pressing the Separation

55F Pinch the Pickup Roller at the rim and the fixing lever, and then remove it.NOTEIf the Pickup Roller is not removed easily because of the fixing l

56J Close the Feed Supporter to the right.K Replace the Roller Cover.L Carefully replace the Top Cover.

57Adjusting the Separation Roller GapIf double feed should occur too often, adjust the Separation Roller gap according to the following procedure.A Sl

58Scanner Specifications Use the recommended operating environment for the ink cartridge when using the imprinter. You can use the functions noted a

59IndexAAdjusting the Print Position ... 23Adjustment Dial...

6INTRODUCTIONThank you for purchasing the Canon Check Reader CR-190i.Please read this manual thoroughly before using the machine in order to familiari

60OOperating Environment ... 18Operation Buttons ...

CANON ELECTRONICS INC.1248, SHIMOKAGEMORI, CHICHIBU-SHI, SAITAMA 369-1892, JAPANCANON U.S.A. INC.ONE CANON PLAZA, LAKE SUCCESS, N.Y. 11042, U.S.A.CANO

7Table of ContentsConnecting the Scanner to a Computer... 2INTRODUCTION ...

8Maintenance ...... 51Replacing the Ink Cartridge...

9Important Safety InstructionsHandlingWARNING Never install and operate the scanner near flammable substances, such as alcohol, paint thinner, benzen