Setting of VoltageBefore using Canon Cine Projector P-400, be sure to set the voltage sw tch at the voltage to be used. The fuse \
2 Pull up the supply reel arm all the way.t When projecting Super 8 or Single 8 film, insert the ™ attached reel shaft adapter into th
Pre-Adjusting for ProjectionThe power switch of the projector is 4-way system. When turned to the red dot, the motor is on: and sta
Film Loading and Projection j Turn the switch knob to the “FWD. & REW.” position.O Insert the tip of the film into the film inserting s
/on the Rewinding Film Guid^ Iv'—f
Film RewindingIWhen projection has been completed, stop the film advance immediately by turning the switch knob to “OFF”. Then wind u
2Remove the film from between the film loading guide and the rubber roller.Open the film guide cover by pulling towards you from the
Changing of FrequenciesThe frequency can be converted to either 50 or 60 cps to suit that of the locale in which the projector is
Replacing of the lampWhen replacing the lamp, be sure to disconnect the electric cord from the power supply.1 Remove the lamp-house cover
CANON CAMERA CO., INC.9-9, Ginza 5-chome, Chuo»ku, Tokyo 104, JapanCANON U.S.A., INC.64-10 Queens Blvd,, Woodside. N,Y. 11377. U.S.A.CANON AMSTERDAM N
' Supply Reel - Reel Shaft -Supply Reel Arm -Take-Up Reel Frequency Conversion Socket---------------------------Side CoverVoltage Indicator Windo
We are highly gratified that you have selected Canon Cine Projector P-400 —a wise choice that promises you many delightful years of
X;— Reel Holding Lever-Angle Adjusting Leg
Technical DataAcceptable filmsFilm loading mechanism LensProjection lamp MotorAcceptable voltagesPower consumption Projection speeds Reel capacity Siz
\I *“655 for Super 8 / S i n g I e 8 film.
Kommentare zu diesen Handbüchern