Canon GPS RECEIVER GP-E1 Bedienungsanleitung PDF herunterladen (Seite 36)

Acquiring GPS Signals

Select [GPS device settings].

Set [GPS device] to [Enable].

If the [Calibrate digital compass]

screen is displayed, follow steps 6 – 7

on p.16.

Viewing GPS Information

Signal acquisition takes about 30 – 60 seconds under favorable

conditions after you turn the camera on.

After initial signal acquisition, signals can be reacquired soon after the

camera is turned on again (under favorable conditions, and when the

camera has been off for less than approx. 30 minutes).

Places with Poor GPS Coverage

Location information may not be recorded, or inaccurate information may be

recorded where GPS signal coverage is poor, such as in the following

places.

Indoors, underground, in tunnels or forests, near buildings or in valleys

Near high-voltage power lines or mobile phones operating on the

1.5 GHz band

When traveling through different environments

Even in other places, GPS satellite movement may interfere with

geotagging and cause missing or inaccurate location information. The

information may also indicate that the camera has been used in a

different location, even if you were shooting at the same place.

Appended Information

If shooting is performed immediately after turning on the camera’s power

switch (or resuming use after auto power off) when the receiver is

attached to the camera, images may not be geotagged. Similarly,

directions may not be recorded correctly. To avoid this, wait a moment

before shooting.

COPY

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 227 228

Keine Kommentare

Canon GPS RECEIVER GP-E1 Bedienungsanleitung Seite 36