Canon DR-4580U Bedienungshandbuch PDF herunterladen (Seite 12)

About the metal clamp

To avoid damage during shipping, the optical unit of the scanner is secured with a metal clamp. Before

moving or installing the scanner, you must install the metal clamp in the specified position.

If you fail to install the metal clamp in the specified position when setting up the scanner, a warning

message will be displayed on the LCD and you will not be able to use the scanner.

Pull the scanner out 15 cm (6 in.) over

the edge of a desk or worktable as

shown in the illustration.

Caution!

•To prevent the scanner from falling, do not allow the scanner to overhang the edge of the

table by more than 15 cm (6 in.)

•To avoid damaging the scanner, never turn it upside down or lay it on its side.

When moving the scanner, install the

metal clamp on the bottom of the

scanner at position

➀

, and when set-

ting up and using the scanner, install

the clamp at position

➁

No more than 15 cm!

15 cm

(6 in.)

➀

➁

Metal clamp

Screw

Before you begin

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Keine Kommentare

Canon DR-4580U Bedienungshandbuch Seite 12