Canon i900D Betriebsanweisung PDF herunterladen (Seite 43)

Troubleshooting

Let’s take a look at countermeasures against troubles which may occur during use of the printer.

“A Message is Displayed on the LCD” on page 42

“Ink does not come out/ Printing is Blurred/ Colors are Wrong/ White Streaks” on page 44

“Printed Surface is Scratched” on page 44

“Cannot Print Properly from the Digital Camera” on page 45

“An Error Message is Displayed While Using the Photo Viewer” on page 46

A Message is Displayed on the LCD

If a message is displayed on the LCD, take the corresponding countermeasure described below.

Here, we will discuss errors indicated on the LCD, problems that might occur during direct printing

from the digital camera, and problems that are also likely to occur while using the Photo Viewer. If

you cannot find the symptom corresponding to a certain problem, refer to the User’s Guide.

Message Try This

No images. Image data edited/processed on the computer should be printed from

the computer, not from the camera.

Waste ink tank almost full. Press the Resume button to recover from the error.

You can print images for a while but you cannot print any more image

when the waste ink tank becomes full. Contact a Canon service

representative.

Read-write mode enabled. The memory card utility started on the computer has write-enabled the

card slot. When the card slot is write-enabled, the printer cannot print

images.

When you have finished writing data to the card, select the read-only

mode. For the cancellation procedure, see “Setting up the Card Slot as

the Memory Card Drive of the Computer” on page 29.

Failed to align print head Press the Resume button and follow the procedure below.

(1) Open the front cover and check if there is ink left. If there is no ink

left, replace the ink tanks

See “Replacing Ink Tanks” on page 35.

(2) Print the nozzle check pattern to verify that the print nozzles are

clean.

See “Printing the Nozzle Check Pattern” on page 38.

(3) Move the printer so that the paper output is not in direct sunlight

and try automatic print head aligning again.

(4) If the error persists, adjust the print head manually.

Cannot communicate with

digital camera.

Disconnect the camera connection cable, press the Resume button,

and then connect the cable once more.

The digital camera should be turned on automatically. If not, turn it on

manually.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Keine Kommentare

Canon i900D Betriebsanweisung Seite 43