Canon BJC-6000 Technical Information PDF herunterladen (Seite 61)

3.2 Description of Error Indications

Errors recoverable by users:

1) Paper feed error

Paper feed operation fails to feed paper.

2) Paper jam error

Paper eject operation of 23 inches still fails to eject the paper.

3) Ink out error

The indicated ink tank is out of ink (ink chamber and sponge).

4) BJ cartridge mis-installed error

The BJ cartridges are not installed in their correct positions.

5) No BJ cartridge error

One or both of the BJ cartridges are not installed.

6) BJ cartridge error

One or both of the BJ cartridges are defective.

7) Waste ink warning

The calculated (and stored in EEPROM) amount of waste ink absorbed has reached

95% of the defined absorbing capacity.

8) Auto head adjustment error

The automatic head position adjustment has failed.

Errors unrecoverable by users:

9) ROM error

ROM checking during initialization is NG.

10) RAM error

RAM checking during initialization is NG.

11) EEPROM error

Writing to EEPROM has failed.

12) Home position error

The home position sensor is defective (broken circuit) or otherwise fails to detect home

position.

13) Temperature sensor error

The thermal sensor (TH201) on the logic board is defective (broken circuit).

14) Waste ink full error

The calculated (and stored in EEPROM) amount of waste ink absorbed has reached

the 100% of defined absorbing capacity.

15) Head temperature error

The inside temperature of the BJ cartridge is too high. This error should occur earlier

than the head temperature sensor error.

16) Head temperature sensor error

The thermal sensor in the BJ cartridge is defective.

17) Cartridge displaced error

The printer cannot detect the BJ cartridge when the carriage is out of the cartridge

replacement position.

18) Ink sensor error

Ink sensor checking during initialization is NG. If this error occurs, no indication is

made, but the printer will not check ink level and assumes that the level is normal

until the printer is switched off. You can confirm the error by printing the EEPROM

information.

19) Pump sensor error

Pump sensor checking during initialization is NG. No indication is made for this

error, but it can be confirmed by printing the EEPROM information.

3-13

BJC-6000

Part 3: Operating Instructions

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 173 174

Kommentare zu diesen Handbüchern

Keine Kommentare

Canon BJC-6000 Technical Information Seite 61

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Canon BJC-6000