Canon VB-H41 Bedienungshandbuch PDF herunterladen (Seite 53)

Add a Camera

Storage Server Settings

Note

• You can only search for cameras on the same subnet as the

Storage Server. For details on how to add cameras on a

different subnet, see “Add Cameras One at a Time” (p. 51).

• The names of the cameras (stored on the camera) are

displayed in the list in the [Camera Search Results] dialog box.

However, the VB-C300 camera name is not displayed.

• Cameras that have already been added are also found.

However, a check box is not displayed next to the camera.

• If you cannot find the camera you are searching for, see “Add

Cameras One at a Time” (p. 51) and add the camera.

• Host names or IPv4 addresses are displayed in the [Host

Name] column of the [Camera Search Results] dialog box.

(IPv6 addresses are not supported.)

Edit Camera Information

You can edit the camera registration information, such as

the camera name or the thumbnail image displayed in the

Viewer.

[General] tab

(1) Camera name box

Enter a camera name.

(2) [Update]

Update the thumbnail image in the camera selection

panel.

(3) [Tags]

Displays the tags assigned to the camera.

(4) [Edit]

Add a new tag to the list in (3).

(5) [Remove]

Remove tags selected in (4).

(6) [OK] and [Cancel]

Close the dialog box.

(7) [Apply]

Apply the settings in the dialog box.

Note

The camera name specified in the text box is only used by this

software product. The camera name stored on the camera is not

changed.

[Advanced] tab

(1) [Host Name]

Change the host name or IP address of the camera.

(2) [Port]

Change the port number used for communicating with

the camera. Typically, leave [80] unchanged.

(3) [User Name]

Change the user name of the camera.

(4) [Password]

Change the password for the user entered in (3).

(5) [Disable Camera]

Disables the camera temporarily. To enable the

camera, click [Enable Camera].

(6) [Storage Server Group]

Displays the Storage Server Group where the camera

is registered.

(7) [OK] and [Cancel]

Close the dialog box.

(8) [Apply]

Apply the settings in the dialog box.

Repeat steps 4 and 5.

When you finish adding cameras click [Cancel].

Select a camera in the list and click [Edit] in the

[Settings] dialog box to display the camera properties.

Configure the displayed settings.

(2)

(3)

(4)

(5)

(1)

(6) (7)

(1)

(3)

(4)

(6)

(5)

(2)

(7) (8)

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare

Canon VB-H41 Bedienungshandbuch Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Canon VB-H41