Canon MLT (F) Bedienungsanleitung Seite 100

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 196
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 99
93
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 hole making tool
 Duct tape
 1 replacement chip
Note: Please read carefully before relling cartridge.
General Relling Procedures:
Make sure you hold this cartridge in an upright position before creating a rell hole
(some remaining or excess toner can and may fall out of the cartridge). Illustration
A on the right shows you where to create a rell hole for your cartridge. Once the
hole has been created, empty any toner left inside the cartridge (mixing two different
brands of toners could result in bad printing, or rare discoloration in your prints).
IMPORTANT: You must dispose of any original toner in the cartridge as much
as possible before relling. Dispose of toner properly into a trash can . Do not
overll the cartridge by pouring the entire toner powder into the cartridge. Use
half the bottle now, and the rest at a later time. Overlling can and will damage a
cartridge.
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen
the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle.
Attach the funnel cap making to sure it is on tightly. Tilt the cartridge at a 45 degree
angle and then the funnel cap toward the lling hole and insert it into the hole. If the
toner stops owing before the cartridge is full, simply remove the toner, close the
cap, turn the bottle upside down and tap it on a table. When you are done relling
this cartridge, simply use duct tape to seal the relling hole back.
Next, you will need to replace the chip. Please follow the diagram to the right for
chip installation instructions. Once you have nished installing the chip, you may
now place your cartridge back into the printer.
HP Q6511A/X
Create Rell Hole
Here
Strip chip off the cartridge and replace with new
chip. Be sure to use gloves and be static free
when replacing chips.
© All rights reserved, Easy Group, LLC. Version 7.6
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
Seitenansicht 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 195 196

Kommentare zu diesen Handbüchern

Keine Kommentare