Canon imagePROGRAF W2200S Bedienungsanleitung PDF herunterladen (Seite 96)

Troubleshooting

6-6

Cannot print from a NetBIOS/NetBEUI network, or the name of a port is

not displayed for “Print to the following port”.

Problem 1: The network interface board and network cable are not connected

correctly.

Solution: Check the following points then cycle the printer off and on.

• Make sure that the correct type of cable is used to connect the printer to

the network. (Æ Setup Guide)

Problem 2: The computer used for printing and the printer are on different subnets.

Solution: This printer cannot execute a print job using NetBEUI protocol on a

network where there is a router between the computer used for printing

and the printer. Use another protocol to execute the print job, or send the

print job to a printer where the print job is not sent through a router.

Problem 3: The settings for the computer used for printing are not set correctly.

Solution: Check the following points:

• Make sure that the correct printer driver has been installed. (Æ Setup

Guide)

• Make sure that correct printer port (print output destination) has been

selected for the printer to be used for printing. In the Control Panel open

the printer folder and then check the output destination.

• Make sure that the setting to finish printing faster has been selected for

Spool Setting. In the Control Panel, open the Printer folder and then

check Spool Setting with the Properties command in the File menu.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 106 107

Keine Kommentare

Canon imagePROGRAF W2200S Bedienungsanleitung Seite 96