Adjusting the Focus
66
One-Shot AF
1 Set the focus mode switch on the lens to AF in advance.
• When using a compatible EF Cinema lens, enable automatic
adjustment on the lens (A 60).
• Refer to the instruction manual of the lens used.
• [AF] will appear on the left of the screen.
2 Press and hold the ONE-SHOT AF button.
• The AF frame will appear at the center of the screen and the
camcorder will focus automatically. When correct focus has been
achieved, the AF frame turns green.
• If the camcorder cannot focus automatically, the AF frame will turn
red.
• The AF frame will disappear when you release the ONE-SHOT AF
button.
Continuous AF
When a compatible EF lens (A 167) is attached to the camcorder, you can have the camcorder focus
automatically.
1 Set the focus mode switch on the lens to AF in advance.
• When using an EF Cinema lens compatible with focus adjustment,
set the lens's focus setting to automatic (A 167).
• Refer to the instruction manual of the lens used.
• [AF] will appear on the left of the screen.
2 Open the [AF Mode] submenu.
[~ Camera Setup] > [AF Mode]
3 Select [Continu.] and then press the joystick.
NOTES
• One-shot AF is not available when the shutter mode is set to [Slow] and the shutter speed is set to 1/4 or 1/3.
• When the frame rate is set to PF30, PF24 or 24P (59.94 Hz recordings) or PF25 (50.00 Hz recordings), the
camcorder will take longer to focus automatically.
•When [~ Camera Setup] > [AF Mode] is set to [Continu.], the ONE-SHOT AF button will be disabled. To use the
button, set it to [One Shot].
• The point where the camcorder focuses may change slightly depending on shooting conditions, such as subject,
brightness and zoom position. Check the focus before resuming shooting.
• Autofocus (one-shot or continuous) is only available when using EF lenses equipped with autofocus (AF)
function. Refer to the instruction manual of the lens used.
• With some EF lenses, the camcorder may take longer to focus automatically or may not be able to focus
correctly. Visit your local Canon Web site for the latest information.
• Continuous AF will not work in the following cases.
- When using an EF lens that does not have a focus mode switch.
- While adjusting the aperture, except when using an EF lens compatible with automatic aperture (A 167).
- While adjusting the focus using a remote controller attached to the REMOTE terminal.
[~ Camera Setup]
[AF Mode]
[One Shot]
Kommentare zu diesen Handbüchern